MN Classic 4.0.2 Logo and Flickering Screen
Moderators: PDJ, Staff Maintenance
-
- Membre
- Posts: 1
- Joined: Mon Aug 24, 2020 10:42 pm
- Donation: 1x donated in total €30.00
- Contact:
MN Classic 4.0.2 Logo and Flickering Screen
Hi,
I have a MN 1 original version was 4.0.2
I tried to update using official software , but it got stuck at loading.
So I checked the inand to be faulty
I managed to write the 4.06 dump to a SanDisk card and when I was testing it was ok.
So while I was putting it back together I am not sure what happened
Now when I power on the logo stays on and the screen flickers every few seconds and nothing loads.
I checked the resistors, they are all 10k.
However when I check the voltage on the cmd pin it's only 1.7v, and when the flicker happens the voltage also changes to 1.9v.
Do you thing I have blown the main cpu ?
I have a MN 1 original version was 4.0.2
I tried to update using official software , but it got stuck at loading.
So I checked the inand to be faulty
I managed to write the 4.06 dump to a SanDisk card and when I was testing it was ok.
So while I was putting it back together I am not sure what happened
Now when I power on the logo stays on and the screen flickers every few seconds and nothing loads.
I checked the resistors, they are all 10k.
However when I check the voltage on the cmd pin it's only 1.7v, and when the flicker happens the voltage also changes to 1.9v.
Do you thing I have blown the main cpu ?
Re: MN Classic 4.0.2 Logo and Flickering Screen
Hello
did you format the storages card and card4 with manamana?
then copy the most recent version 4.1.0.
version 4.0.2 is not successful, as generally it is the processor which burns.
did you format the storages card and card4 with manamana?
then copy the most recent version 4.1.0.
version 4.0.2 is not successful, as generally it is the processor which burns.
Who is online
Users browsing this forum: No registered users and 3 guests